REVERSE OSMOSIS INSTALLATION AND OPERATION MANUAL Model R13
C. ELECTRICAL Note: It is the responsibility of the end user to ensure that the installation is done according to local codes and regulations. 1.
The quality meter is powered by two AAA batteries. To replace the batteries, lift the meter out of the bracket and remove the back cover.
F. Operation and Maintenance Log DATE PRODUCT GPM REJECT GPM PUMP DISCHARGE PRESSURE FEED TDS PPM PRODUCT TDS PPM FEED WATER TEMP FEED WATER HARD
G. TROUBLESHOOTING RO MEMBRANE TROUBLE SHOOTING GUIDE SYMPTOMS Salt Passage Permeate Flow Pressure Drop Location Possible Causes Verificati
RO SYSTEM TROUBLE SHOOTING PROBLEM REMEDY General High Product Water TDS Membrane frozen, high temp, or backpressure. Replace membrane. Membrane
V. MEMBRANE REPLACEMENT 1. Turn off the system and close the feed water shutoff valve. 2. Disconnect the tubing from the bottom of the m
VI. APPENDIX The following tables are intended as a guide to determining the flow rates for the R13 series RO systems. All flows are in gallons
IMPORTANT Please read the entire manual before proceeding with the installation and startup: Do not use where the water is microbiologically uns
TABLE OF CONTENTS I. Introduction A. Specifications B. RO Overview C. Pre-treatment II. Controls, Indicators, and Components III. Operation A
I. INTRODUCTION The separation of dissolved solids and water using RO membranes is a pressure driven temperature dependent process. The membrane
B. RO OVERVIEW Reverse osmosis systems utilize semipermeable membrane elements to separate the feed water into two streams. The pressurized feed wa
Prefilter Cartridge - Used to remove smaller suspended solids and trap any particles that may be generated by the other pretreatment. The cartridge(
Figure 1
III. OPERATION A. INSTALLATION 1. Proper pretreatment must be determined and installed prior to the RO system. 2. The water supply and pretre
Comments to this Manuals