Watts R14-03-1WM User Manual

REVERSE OSMOSIS INSTALLATION AND OPERATION MANUAL R14-Wall Mount ALAMO WATER REFINERS

III. OPERATION A. INSTALLATION 1. The water supply should be sufficient to provide a minimum of 20 psig pressure at the design feed flow.

D. STARTUP 1. Verify that the pretreatment equipment is installed and working properly. Verify that no free chlorine is present in the feed water

E. Controller 1. When the power switch is turned on, the pump will run as long as the circuit between the tank level terminals and the interlock

F. Operation and Maintenance Log DATE PRODUCT GPM REJECT GPM PUMP DISCHARGE PRESSURE REJECT PRESSURE FEED TDS PPM PRODUCT TDS PPM FEED WATER TEMP

F. TROUBLESHOOTING RO TROUBLE SHOOTING GUIDE SYMPTOMS Salt Passage Permeate Flow Pressure Drop Location Possible Causes Verification Corre

MOTOR TROUBLE SHOOTING CHART TROUBLE CAUSE WHAT TO DO Motor fails to start Blown fuses Replace fuses with proper type and rating Overload trip

MOTOR TROUBLE SHOOTING CHART (CONTINUED) TROUBLE CAUSE WHAT TO DO Unbalanced line current Unequal terminal volts Check leads and connections on

IV. REPLACEMENT PARTS LIST A list of common replacement parts is provided below Contact you dealer for replacement parts assistance. Part Numb

VI. APPENDIX Temperature Correction Factors Deg C Deg F Correction Factor 30 86 1.16 29 84.2 1.13 28 82.4 1.09 27 80.6 1.06 26 78.8 1.03

Power Input To Pump

Alamo Water Refiners, Inc. 13700 Hwy. 90 West San Antonio, TX 78245 U.S.A. 210-677-8400 www.alamowater.com

IMPORTANT Please read the entire manual before proceeding with the installation and startup:  Do not use where the water is microbiologically uns

TABLE OF CONTENTS I. Introduction A. Specifications B. Overview C. Pre-treatment II. Controls, Indicators, and Components A. Figu

I. INTRODUCTION The separation of dissolved solids and water using RO membranes is a pressure driven temperature dependent process. The membrane

A. SPECIFICATIONS Productivity (Gallons per day / Gallons per minute) Maximum production based on standard membranes and feed water of 25°C, SD

C. PRETREATMENT The RO feed water must be pretreated in order to prevent membrane damage and/or fouling. Proper pretreatment is essential for reli

II. CONTROLS, INDICATORS, and COMPONENTS (see figure 1) A. Controller - Controls the operation of the system. B. Reject Control Valve - Controls

Figure 1