Watts WFTK User Manual

Browse online or download User Manual for Water equipment Watts WFTK. Watts WFTK User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
A
B
D
E
G
F
LARGE VALVE REASSEMBLY
Installation:
1. Close supply and return side valves and let steam trap cool.
2. Remove bolts, wire brush clean if needed, and put aside. Re-
move trap body, leaving trap cover attached to system piping.
Remove and discard cover gasket, make sure that the body
and cover flange are clean and all remnants of old gasket
are scraped off. Clean out any debris/sludge from inside trap
body.
3. Remove thermostatic vent and vent seat, discard. Install new
thermostatic vent seat (A) and make wrench tight (approxi-
mately 25 ft - lbs). Place thermostatic capsule (B) and snap-
on to vent seat by pushing the middle back of capsule with
thumb.
4. Refer to above drawing (D & E) and remove old condensate
valve assembly,  oat and linkage. Replace same and torque
condensate valve seat to 25 ft - lbs.
5. Reinstall body (F) using new cover gasket (G) and torque bolts
to 25-40 ft - lbs.
6. Slowly open supply valve, then slowly open return side valve.
Check and retorque bolts after trap is at operating tempera-
ture.
Series WFTK F&T Repair Kits
Installation Instructions
IS-WFTK
IS-WFTK 0829 EDP# 1910797
© Watts, 2008
USA: 815 Chestnut St., No. Andover, MA 01845-6098; www.watts.com
Canada: 5435 North Service Rd., Burlington, ONT. L7L 5H7; www.wattscanada.ca
Water Safety & Flow Control Products
Limited Warranty: Watts Regulator Co. (the “Company”) warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of
original shipment. In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER
WARRANTIES, EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special
or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting
from labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no
control. This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the above
limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state laws to
determine your rights. SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.
IS-WFTK.indd 1 9/12/08 1:00:46 PM
Page view 0
1 2

Summary of Contents

Page 1 - Installation Instructions

ABDEGFLARGE VALVE REASSEMBLYInstallation:1. Close supply and return side valves and let steam trap cool.2. Remove bolts, wire brush clean if needed,

Page 2

Series WFTK F&T Repair KitsInstallation Instructions IS-WFTKABDEGFLARGE VALVE REASSEMBLYInstallation:1. Close supply and return side valves and

Comments to this Manuals

No comments